For the parameters of the EMA formulas (CustomEMA and SellByCustomEMA), an Avg(X,Y) average price comparison formula has been added to the MoonBot terminal; formulas are recorded by analogy with the EMA(X,Y) formulas, that is, the average price X seconds or minutes ago and the average price Y seconds or minutes ago are compared. If Y=1, […]
In the strategy settings of the MoonBot terminal, you can make a special case of setting stops to make an instant sale. If you check FastStopLoss = YES, StopLossDelay = 0 and set StopLoss to a positive value on the Stops: stop settings tab, then the Sell order is immediately set to = purchase price
In the MoonBot terminal, the formula Vol(X,Y) has been added for the parameters of the EMA formulas (CustomEMA on the Filters / Base tab and SellByCustomEMA on the Sell order tab), where X and Y can be selected from the following fixed values: 5s, 15s, 30s, 1m, 3m, 5m, 15m, 30m, 1h, 3h, 24h.The calculation
In the MoonBot terminal, on the Filters / Ping tab, the BinancePriceBug parameter is available on all exchanges. In order for this parameter to be checked by the strategy, you need to set IgnoreFilters = NO on the general Filters tab, and set IgnorePing = NO on the Filters / Ping tab, while a green
Is the BinancePriceBug filter available on all MoonBot terminal exchanges? Read More »
When using “Manual Moonhooks” in the MoonBot terminal (the Manual + MoonHook paired algorithm), the settings for a Sell order after executing a Buy order are taken from the Sell order tab (for the PriceDown, SellLevel parameter group), on the Sell order / SellShot tab (for the SellShot parameter group), on the Sell order/ SellSpread
In the MoonBot terminal, on the Filters / Ping tab of the strategy settings, the BinancePriceBugMin parameter is located: use only those coins where the price lag value (PriceBug) is greater than the value set in it. If 0, it does not apply. Please note that the price lag exists only on the Binance exchange,
When using “Manual Moonhooks” in the MoonBot terminal (the Manual + MoonHook paired algorithm), the height of the placed Sell order after the execution of the Buy order depends on:1) depending on the value in the HookSellLevel parameter of the MoonHook strategy, the higher the value, the higher the Sell purchased from one distance in
If you have set up a grid with pending orders in the MoonBot terminal in the strategy settings, for example, BuyType = BuyLimit (order type: deferred BuyLimit) and CancelBuyAfterSell = YES (cancel the remainder of the grid with Buy orders after selling one of the orders in it), then in recent versions the same algorithm
When using “Manual Moonhooks” (paired Manual + MoonHook algorithm) in the MoonBot terminal, the delta modifier settings are taken from the Delta Modifiers tab of the MoonHook strategy. For example, in the MoonHook strategy, you can add an addition to the SellModifier parameter and the height of the Sell order for the “Manual Moonhook” after
In the MoonBot terminal, on the Stops tab, the DontSellBelowLiq strategy parameter is used in order to be able not to sell a position at a stop below the liquidation price. If the check mark is set, the stop will attempt to sell above the liquidation price. The option is applied only on an isolated
