Interface configuration

The “3m vol” column in the “MarketsTable” is the three minute volumes on the coin.

In the MoonBot terminal, in the Menu – System Settings window, there is a setting: “Ignore Scale” – Ignore Monitor Scaling (tick only If you have problems with current monitor scaling).

 On the main window of the MoonBot spot terminal, you can change the scale of the chart using the fixed buttons, and two scales with scale are available:1) If the x9 button is not pressed, the following selection of scale values is available: 100%, 50%, 20%, 10%, 5%, Auto.2) If the x9 button is pressed,

In the latest versions of the MoonBot terminal for the Bybit exchange, the ability to trade on USDC pairs has been added. We recommend that you update your version of the MoonBot terminal to the latest version.

The “5m vol” column in the “MarketsTable” is the five minute volumes on the coin.

In Menu – System Settings, the “Use memory for charts: XX%” slider is now available in VPS mode on a 1GB VPS with paging enabled. This setting affects the number of crosses on the chart in the report. It is strongly recommended to increase its value only on 2GB VPS!

On the main window of the MoonBot futures terminal, you can change the scale of the chart using the fixed buttons, and two scales with scale are available:1) If the x9 button is not pressed, the following selection of scale values is available: 50%, 20%, 10%, 5%, 2%, Auto.2) If the x9 button is pressed,

Due to the rebranding of the Huobi exchange and renaming it to the HTX exchange in the MoonBot terminal, the exchange was renamed from Huobi to HTX in the Settings-Login tab, the old HT token was replaced with the new HTX token and is now shown in millions of tokens on the main window of

The “3h. Delta” column in the “MarketsTable” is the three hourly deltas of coins.

If you go to Menu – System Settings in the MoonBot terminal, you can see the current paging file size in this window. We strongly recommend setting the paging file size to a fixed 4 GB. To do this, click the “Set PageFile-Control panel” button in the System Settings window, which will open the System