Interface configuration

The “3m vol” column in the “MarketsTable” is the three minute volumes on the coin.

In the MoonBot terminal, in the Menu – System Settings window, there is a setting: “Ignore Scale” – Ignore Monitor Scaling (tick only If you have problems with current monitor scaling).

 On the main window of the MoonBot spot terminal, you can change the scale of the chart using the fixed buttons, and two scales with scale are available:1) If the x9 button is not pressed, the following selection of scale values is available: 100%, 50%, 20%, 10%, 5%, Auto.2) If the x9 button is pressed,

In the latest versions of the MoonBot terminal for the Bybit exchange, the ability to trade on USDC pairs has been added. We recommend that you update your version of the MoonBot terminal to the latest version.

The “1m vol” column in the “MarketsTable” is the minute volumes on the coin.

The “Settings-Advanced-Hang Control” tab implements the functionality of automatic tracking of hung positions and on this tab, below the table with API keys of controlled accounts, there is a button for manual cancellation of orders on all terminals.

This is done specifically to optimise the CPU when calculating filters and the line with the record of EMA conditions in the upper left corner of the coin chart will be visible only if the Funnel button is enabled (show filters on the chart) and if the coin chart is opened in full screen mode,

On the main MoonBot terminal window, you can click on the “Show Spot trades\ OrderBook” button, which is located to the left of the “Funnel” button (Filters on charts) and open a window with additional parameters:Show Spot Trades: show spot trades (shown paler than the current pair).Show Spot Book: show spot trade book.Show Mark Price:

In the MoonBot terminal on the main screen, click on the “Show Markets” button and open the “MarketsTable” window. In the lower part of this table, click “Manage Leverage” and in the opened additional configuration you will see the Config field (configuration lines), in which the desired position limits are written, under which the maximum

To do this, you need to do the following in the MoonBot terminal:n1) On the Settings-Advanced-Engine settings tab, tick the Auto Leverage option (automatic leverage change up to x5 if the position limit is exceeded). n2) Click on the “Show Markets” button and then at the bottom of the “MarketsTable” click on the “Manage Leverage”