Strategy settings

You can monitor the market in the MoonBot terminal with these strategies: – Pump detection (for growth) – Drops detection (downward). – EMA (if the AutoTrading module is purchased) – Delta (delta change) – TorMarket (the most volatile coin in 15 minutes). These strategies can be set up as only detects that will open a […]

The MoonHook strategy’s order reduction function can be seen in the log for the following entry: BTC: [1] (40) Buy order reduced: 1000.00$ => 23.32$ (Vol: 23.32$). In this log, the OrderSize of the strategy was 1000$, while the average trading volume over 100ms was only 23$, thus the startegy has placed a buy order

Specific parameters of the MoonHook strategy: BuyOrderReduce: sets the interval (in ms) used to calculate the average trade volume. The strategy will place an order of size not larger than the average volume. By default = 100ms. Volume calculation: sum of all trades (buy and sell) over the TimeInterval interval, divided by BuyOrderReduce. Examlple: if

Yes, the BuyModifier parameter in the MoonHook strategy, unlike other strategies, affects the width and depth of the corridor in this strategy. How it works: The deltas are fixed at the time of detection. Then, if the delta starts growing, the difference between the current delta and the one fixed at the moment of detection,

The MoonHook strategy is only available to bonus program participants and with the PRO version. This strategy detects a rapid drop in price, checks for a pullback, and places a buy order, which then moves in its own price corridor, as in a munschot, waiting for a second strike. Both the corridor and the initial

When the Spread strategy works, you can observe the detection parameters on the chart (to do this, the Extended Debug Mode checkbox must be enabled on the Settings-Special-System tab): TD: trade densityd P: price fluctuation on the entire interval TimeInterval Vol: volume Spread: actual spread, percent N: number of slices showing the spread (the last

If you have several Spread strategies enabled in your MoonBot terminal, then detection and orders will be performed for each of them, since its IndependentSignals parameter is always set to YES and cannot be adjusted by the user.

Example of setting the Spread strategy with decoding: TimeInterval=5 sec. TradesDensity=100 PriceIntervals=5 PriceSpread=0.3 IntervalsForBuySpread=2 BuyPriceInSpread=5 SellPriceInSpread=100 BuyOrderReduce=100 From these settings, it follows that there was a 0.3% (PriceSpread=0.3) or higher price movement every second for the last 5 seconds (TimeInterval=5). To calculate the Buy and Sell orders, we take the last 2 intervals (IntervalsForBuySpread=2), set

The polarity in the Spread strategy is its direction, a numerical value of the price direction from +100 (strictly up) to -100 (strictly down).

The work of the order reduction function can be seen in the log by the following record of the form: BTC: [1] (40) Buy order reduced: $1000.00 => $23.32 (Vol: $23.32)In this log the OrderSize of the strategy was $ 1000, but the average trading volume was only $ 23 per 100 ms, so the