Strategy settings

If you have a non-zero value set in the StopAboveLiq parameter in the MoonBot terminal on the Stops tab of the strategy settings, then it will determine the level at which the stop loss will be set relative to the liquidation price. According to your settings, the strategy has a stop loss of -1%, a […]

In the MoonBot terminal, on the Strategy settings tab of the MoonShot strategy settings, the value of the MShotReplaceDelay parameter is set in the “seconds, with a dot” format, which allows you to set a shorter (less than 1 second) or fractional time delay before reshuffling the Buy order after the price increases.

Previously, in the MoonBot terminal, the BinanceTokenTags parameter on the Filter /Base tab of the strategy settings was developed only for the Binance exchange, and in the latest versions of the terminal this parameter is available for all exchanges. We recommend updating the terminal to the current version.

In the MoonBot terminal, on the Strategy settings tab of the MoonShot strategy settings, the value of the MShotRaiseWait parameter is set in the “seconds, with a dot” format, which allows you to set a shorter (less than 1 second) or fractional time delay before reshuffling the Buy order after the price increases.

For the parameters of the EMA formulas (CustomEMA and SellByCustomEMA), an Avg(X,Y) average price comparison formula has been added to the MoonBot terminal; formulas are recorded by analogy with the EMA(X,Y) formulas, that is, the average price X seconds or minutes ago and the average price Y seconds or minutes ago are compared. If Y=1,

In the strategy settings of the MoonBot terminal, you can make a special case of setting stops to make an instant sale. If you check FastStopLoss = YES, StopLossDelay = 0 and set StopLoss to a positive value on the Stops: stop settings tab, then the Sell order is immediately set to = purchase price

In the MoonBot terminal, the formula Vol(X,Y) has been added for the parameters of the EMA formulas (CustomEMA on the Filters / Base tab and SellByCustomEMA on the Sell order tab), where X and Y can be selected from the following fixed values: 5s, 15s, 30s, 1m, 3m, 5m, 15m, 30m, 1h, 3h, 24h.The calculation

In the MoonBot terminal, in the Spread strategy settings on the Strategy settings tab, for the timeInterval parameter: the time zone width in seconds in which the Spread strategy detection is calculated, the minimum value is 1 second.

Triggers will persist after restarting the MoonBot terminal if less than an hour has passed.

The MoonBot terminal has significantly optimized the speed of triggers, and this optimization will be noticeable if you use a large number of strategies (from 50).