Strategy settings

On the Filters tab of the MoonBot terminal’s strategy settings is the DontCheckBeforeBuy: Do not recheck filters immediately before buying. By default it is off, filters are checked twice: before calculating the detection and before buying.

In the MoonBot terminal in the strategy settings, if DontCheckBeforeBuy is checked and CheckAfterBuy is unchecked, pending orders are not removed even if they stop passing through the filters.

Yes, such an algorithm can be implemented and it can be useful, for example, if you know that some coins go the same way and when one coin pumps, after some time another coin starts to pump. Then you can set the detector on one “guide” coin, buy it or just give detector from it

On the Filters tab of the MoonBot terminal strategy settings, there is a MaxBalance parameter: do not place an order if the balance already used by all strategies exceeds the limit specified in this parameter, including the OrderSize of this strategy. If 0, it is not taken into account. Please note! The parameter will not

In the MoonBot terminal, in the strategy settings on the Delta Modifiers tab, there is a parameter MaxModifier: this is the calculated sum of all modifiers not greater than the specified value. The total modifier is calculated using the formula Min(MaxModifier, Sum[Pn * Dn]), where Pn is the modifier specified in the strategy, Dn is

 On the Filters tab of the MoonBot strategy settings, there is a parameter called MaxPing: The maximum ping value in milliseconds to which the strategy can work. If it is 0, or if MaxLatency is 0, it is not considered.If an order fails to pass the ping filter, a penalty of 5 seconds is imposed

Yes, the MaxModifier parameter also applies to the MoonShot strategy and allows you to limit the maximum coefficient of modifiers.

On the Filters tab of the MoonBot terminal strategy settings, there is a MinPing parameter: The minimum ping value in milliseconds from which the strategy can operate.

In the MoonBot terminal, in the strategy settings on the Filters tab, there is a parameter MaxLeverage (maximum leverage), up to which to take coins into work. If the leverage on coins is higher than the specified leverage, the strategy will not take such coins into work. If IgnoreFilters = YES is checked, this filter

The Binance exchange uses special tags for some tokens, which can be presented in various combinations. You can filter coins with tags using the parameter on the Filters tab of the strategy settings TokenTags= token tag field (Binance only!). Acceptable tags in the field of this parameter are Monitoring, Fan, Seed, Launch, Gaming. The tokens