FAQs

To do this, in the MoonBot terminal, on the Buy conditions tab of the strategy settings, use the AutoCancelBuy parameter: Auto cancellation of a Buy order after a specified time, in seconds. If 0, do not cancel. The counter until cancellation is reset if the Buy order was manually repositioned.

Such a limit can be set in the MaxOrdersPerMarket parameter, which is responsible for setting the maximum number of active multi-order on a single coin. In your case, this parameter should be set as follows: MaxOrdersPerMarket=1.

If you want to run munches on specific 9 coins, specify a comma separated list of these coins in the white list parameter: CoinsWhiteList. If you want to put MoonShots in the whole market, but not more than 9 of any coins, then use MaxMarkets parameter, which is responsible for the maximum number of marks

Yes, you can do that with the MaxActiveOrders parameter which is responsible for the maximum number of active (pending or already Sell after Buy trigger) orders for the strategy at the same time.

The MaxActiveOrders parameter, which is responsible for the maximum number of active (pending or already placed for sale after a Buy trigger) orders for a given strategy at the same time, does not apply to repeat orders of the Munschot with the MShotRepeatAfterBuy option. The repeated orders will be placed without taking into account the

The “HFT” parameter is an integer and indicates the time window in milliseconds during which the order is valid. If 0, it does not apply. If a dedicated server with the MoonBot terminal installed on it has increased ping, the order command will take too long to reach the Binance exchange. If a small window

Use the BuyDelay: Order placement delay in milliseconds (0 – no delay, max 3000 msec) in the strategy setup.

Use the Short: Open short orders instead of long orders in the strategy settings. The “Binance Futures” module is required to place a short order, as well as the short order settings for futures strategies.

If you need to activate a Slave strategy after a trade finishes on a Master strategy regardless of its result (profit or loss), you need to write the same keys in the TriggerKeyProfit and TriggerKeyLoss parameters. For example, TriggerKeyProfit=3 and TriggerKeyLoss=3, in this case, at any variant of profit or loss, key 3 will be

To do this, use the AutoBuy: AutoBuy Coins option in the strategy setting. If YES, a buy order is placed according to the following parameters. If NO, the strategy will give a signal, but will not buy, which is useful when you are using the strategy as an assistant to select coins for manual trading.