FAQs

This is done specifically to optimise the CPU when calculating filters and the line with the record of EMA conditions in the upper left corner of the coin chart will be visible only if the Funnel button is enabled (show filters on the chart) and if the coin chart is opened in full screen mode, […]

On the main MoonBot terminal window, you can click on the “Show Spot trades\ OrderBook” button, which is located to the left of the “Funnel” button (Filters on charts) and open a window with additional parameters:Show Spot Trades: show spot trades (shown paler than the current pair).Show Spot Book: show spot trade book.Show Mark Price:

In the MoonBot terminal on the main screen, click on the “Show Markets” button and open the “MarketsTable” window. In the lower part of this table, click “Manage Leverage” and in the opened additional configuration you will see the Config field (configuration lines), in which the desired position limits are written, under which the maximum

To do this, you need to do the following in the MoonBot terminal:n1) On the Settings-Advanced-Engine settings tab, tick the Auto Leverage option (automatic leverage change up to x5 if the position limit is exceeded). n2) Click on the “Show Markets” button and then at the bottom of the “MarketsTable” click on the “Manage Leverage”

To do this, click on the “Show Markets” button in the MoonBot terminal on the main screen and open the “MarketsTable” window. At the bottom of this table, click “Manage Leverage” and in the additional setting that opens, tick the “Allow leverage Up” option: increase leverage if the required limit can be reached with a

In the MoonBot terminal, if “Allow leverage Up” is ticked (leverage up if the required limit can be reached at a higher leverage), the check for leverage up is performed once an hour.

Yes, you can. To do this, click “Show Markets” in the MoonBot terminal on the main screen and open the “MarketsTable” window. At the bottom of this table, click “Manage Leverage” and in the additional setting that opens, uncheck the Telegram reporting option, in this case notifications to Telegram about leverage changes will not be

To do this, click “Show Markets” in the MoonBot terminal on the main screen and open the “MarketsTable” window. At the bottom of this table, click “Manage Leverage” and in the additional setting that opens, tick the “Auto leverage” option: automatically change the leverage to reach the specified maximum order.

To do this, click on the “Show Markets” button in the MoonBot terminal on the main screen and open the “MarketsTable” window. At the bottom of this table, click on “Manage Leverage” and in the additional setting that opens, click on “Make ALL Cross” – change the margin type to cross on all markets and

To do this, click on the “Show Markets” button in the MoonBot terminal on the main screen and open the “MarketsTable” window. At the bottom of this table, click “Manage Leverage” and in the additional setting that opens, tick the “Auto Isolated” option to automatic switch to isolated margin after listing and click “Apply”.